Even if you aren’t, you’ll then need to take this bracket and install back into the iMac and secure it using the two original screws that you removed in order to take the optical drive out, since the bracket is integrated into the iMac’s assembly. If you’re replacing the optical drive (either with another optical drive or a hard drive bay), screw it into the bracket now.

It’s held together with four T8 Torx screws, two on each side. Next, you’ll need to remove the black bracket that holds the optical drive in place inside of the iMac. Remember to leave the other end plugged into the logic board. It’s connected to the drive with adhesive, so remove the foam covering the sensor and then use a spudger or something with a flat edge to pry off the temperature sensor assembly from the optical drive’s surface. This will loosen the bezel and you can begin to work your way down until the whole bezel lifts up. Do this very slowly and carefully, as there is a cable you’ll need to disconnect! Place your thumb on the edge of the display unit and your fingers on the back side of the iMac. From there, push your thumb down as your pull up your fingers. The best way to do this is by starting in the upper corners. Be aware that the four screws along the bottom are longer than the rest, so make sure you put them back in the correct locations.Īfter you remove these screws, it’s time to remove the whole front bezel. Next, there are twelve T8 Torx screws around the edge of the display that need removed.

If you’re worried about scratching it, place it on a soft surface away from the work area and then lay a towel or sheet over it to prevent it from collecting dust. The glass is simply held on by magnets, so all you have to do is lift straight up and the glass panel will come right off. Next, take your suction cups and place them in opposite corners of the screen, making sure to lock them in place so that they grab on to the glass.

Internal hard drive for imac 2007